Document Detail

MBM fuel feeding system design and evaluation for FBG pilot plant.
MedLine Citation:
PMID:  22349101     Owner:  NLM     Status:  Publisher    
A biomass fuel feeding system has been designed, constructed and evaluated for a fluidized bed gasifier (FBG) pilot plant at the University of Saskatchewan (Saskatoon, SK, Canada). The system was designed for meat and bone meal (MBM) to be injected into the gasifier at a mass flow-rate range of 1-5g/s. The designed system consists of two stages of screw conveyors, including a metering stage which controlled the flow-rate of fuel, a rotary airlock and an injection conveyor stage, which delivered that fuel at a consistent rate to the FBG. The rotary airlock which was placed between these conveyors, proved unable to maintain a pressure seal, thus the entire conveying system was sealed and pressurized. A pneumatic injection nozzle was also fabricated, tested and fitted to the end of the injection conveyor for direct injection and dispersal into the fluidized bed. The 150mm metering screw conveyor was shown to effectively control the mass output rate of the system, across a fuel output range of 1-25g/s, while the addition of the 50mm injection screw conveyor reduced the irregularity (error) of the system output rate from 47% to 15%. Although material plugging was found to be an issue in the inlet hopper to the injection conveyor, the addition of air sparging ports and a system to pulse air into those ports was found to successfully eliminate this issue. The addition of the pneumatic injection nozzle reduced the output irregularity further to 13%, with an air supply of 50slpm as the minimum air supply to drive this injector. After commissioning of this final system to the FBG reactor, the injection nozzle was found to plug with char however, and was subsequently removed from the system. Final operation of the reactor continues satisfactorily with the two screw conveyors operating at matching pressure with the fluidized bed, with the output rate of the system estimated based on system characteristic equations, and confirmed by static weight measurements made before and after testing. The error rate by this method is reported to be approximately 10%, which is slightly better than the estimated error rate of 15% for the conveyor system. The reliability of this measurement prediction method relies upon the relative consistency of the physical properties of MBM with respect to its bulk density and feeding characteristics.
William A Campbell; Terry Fonstad; Todd Pugsley; Regan Gerspacher
Publication Detail:
Type:  JOURNAL ARTICLE     Date:  2012-2-18
Journal Detail:
Title:  Waste management (New York, N.Y.)     Volume:  -     ISSN:  1879-2456     ISO Abbreviation:  -     Publication Date:  2012 Feb 
Date Detail:
Created Date:  2012-2-21     Completed Date:  -     Revised Date:  -    
Medline Journal Info:
Nlm Unique ID:  9884362     Medline TA:  Waste Manag     Country:  -    
Other Details:
Languages:  ENG     Pagination:  -     Citation Subset:  -    
Copyright Information:
Copyright © 2012 Elsevier Ltd. All rights reserved.
Fluidization Laboratory of Saskatchewan (FLASK™), Canada; Department of Chemical and Biological Engineering, University of Saskatchewan, Canada.
Export Citation:
APA/MLA Format     Download EndNote     Download BibTex
MeSH Terms

From MEDLINE®/PubMed®, a database of the U.S. National Library of Medicine

Previous Document:  Characterization and tropical seasonal variation of leachate: Results from landfill lysimeter studie...
Next Document:  Flaring spreader flaps and upper lateral advancement : Modified techniques in the reconstruction of ...