Self-assembled monolayers inherently possess polarizable dielectric components. In contact with a solution phase, these components are present in addition to the more generalized framework of non faradaic processes encompassing double layer capacitance and electrolyte resistance. The presence of such films, then, introduces additional capacitative and resistive terms that can have ...

A simple and efficient route for quantum dot (QDs) patterning using self-assembled monolayers (SAMs) as templates is described. By means of a laser direct-writing (LDW) technique, SAMs of octadecylphosphonic acid formed by adsorption on native oxide layer of titanium film were patterned through laser-induced ablation of the SAM molecules. This ...

Recently, microbiologists have established the existence of biogeographic patterns among a wide range of microorganisms. The focus of the field is now shifting to identifying the mechanisms that shape these patterns. Here, we propose that four processes - selection, drift, dispersal and mutation - create and maintain microbial biogeographic patterns ...

Robust directed self-assembly of non-periodic nanoscale structures is a key process that would enable various technological breakthroughs. The dynamic evolution of directed self-assemblies towards structures with desired geometries is governed by the rugged potential energy surface of nanoscale systems, potentially leading the system to kinetic traps. To study such phenomena ...

In this paper, we report the development of an optical sensor network (OSN) based on piezoelectrically actuated corner cube retroreflectors (PA-CCRs). PA-CCRs were fabricated by microelectromechanical systems processes and assembled by aligning horizontally actuated mirrors and vertical side walls in a holder, which allows mass production. Fabricated PA-CCRs showed a ...

Microtubules in spindles are too dense to resolve by light microscopy, even with super-resolution methods. Using a new method based on laser-ablation techniques, Brugués et al. present the first quantitative characterization of the vertebrate meiotic spindle and propose an assembly mechanism for building this architecture.

We present that two distinct optical properties of light, the spin angular momentum (SAM) and the orbital angular momentum (OAM), can be coupled in the plasmonic vortex. If a plasmonic vortex lens (PVL) is illuminated by the helical vector beam (HVB) with the SAM and OAM, then those distinct angular ...

Dip-in direct-laser-writing (DLW) optical lithography allows fabricating complex three-dimensional microstructures without the height restrictions of regular DLW. Bow-tie elements assembled into mechanical metamaterials with positive/zero/negative Poisson's ratio and with sufficient overall size for direct mechanical characterization aim at demonstrating the new possibilities with respect to rationally designed effective materials.

AR-NW12A is an in-vacuum undulator beamline optimized for high-throughput macromolecular crystallography experiments as one of the five macromolecular crystallography (MX) beamlines at the Photon Factory. This report provides details of the beamline design, covering its optical specifications, hardware set-up, control software, and the latest developments for MX experiments. The experimental ...

Although nanoparticle (NP) assemblies are at the beginning of their development, their unique geometrical shapes and media-responsive optical, electronic, and magnetic properties have attracted significant interest. Nanoscale assembly bridges multiple levels of hierarchy of materials: individual nanoparticles, discrete molecule-like or virus-like nanoscale agglomerates, microscale devices, and macroscale materials. The capacity ...

Au/Pd octopods, nanostructures with eight branches and a primarily Au interior, have been synthesized as size-controlled samples through the manipulation of seed-mediated co-reduction. The position of their localized surface plasmon resonance can be controllably tuned throughout the visible and near-infrared regions, and this response is correlated with the structural features ...

DC electric fields are used to produce colloidal assemblies with orientational and layered positional order from a dilute suspension of spheroidal particles. These 3D assemblies, which can be visualized in situ by confocal microscopy, are achieved in short time spans (t < 1 h) by the application of a constant ...

Molecular building blocks interacting at the nanoscale organize spontaneously into stable monolayers that display intriguing long-range ordering motifs on the surface of atomic substrates. The patterning process, if appropriately controlled, represents a viable route to manufacture practical nanodevices. With this goal in mind, we seek to capture the salient features ...

We consider the self-assembly of composite structures from a group of nanocomponents, each consisting of particles within an N-atom system. Self-assembly pathways and rates for nanocomposites are derived via a multiscale analysis of the classical Liouville equation. From a reduced statistical framework, rigorous stochastic equations for population levels of beginning, ...

Au nanocrystals (NCs) with an unprecedented hexoctahedral structure enclosed exclusively by high-index {321} facets have been prepared for the first time. Manipulating the NC growth kinetics by controlling the amount of reductant and the reaction temperature in the presence of a suitable surfactant is the key synthetic lever to control ...

Coarse-grained features of macromolecular assemblies are understood via a set of order parameters (OPs) constructed in terms of their all-atom configuration. OPs are shown to be slowly changing in time and capture the large-scale spatial features of macromolecular assemblies. The relationship of these variables to the classic notion of OPs ...

The integration of top-down (lithographic) and bottom-up (synthetic chemical) methodologies remains a major goal in nanoscience. At larger length scales, light-directed chemical synthesis, first reported two decades ago, provides a model for this integration, by combining the spatial selectivity of photolithography with the synthetic utility of photochemistry. This review describes ...

The manipulation of the chirality and corresponding optical activity in the visible-near infrared (NIR) light region is significant to realize the applications in the fields of chemical sensing, enantioselective separation, chiral nanocatalysis and optical devices. We studied the plasmon-induced circular dichroism (CD) response by one dimensional (1D) assembly of cysteine ...

Compartmentalization is essential in the organization of biological systems, playing a fundamental role in modulating biochemical activity. An appreciation of the impact that biological compartments have on chemical reactions and an understanding of the physical and chemical phenomena that affect their assembly and function have inspired the development of synthetic ...

In this paper spatial dynamics of the Beddington-DeAngelis predator-prey model is investigated. We analyze the linear stability and obtain the condition of Turing instability of this model. Moreover, we deduce the amplitude equations and determine the stability of different patterns. In Turing space, we found that this model has coexistence ...

A direct transfer patterning process is presented that allows metallic patterns to be stamped onto a contoured substrate. This process was used to make some of the most efficient electrically small antennas to date, while maintaining bandwidths approaching the physical limit.

This review summarizes the work conducted in the last decade on the fabrication of mesostructured patterns, which have lateral dimensions within the nano- and microscales, over a wafer-scaled size by means of dynamic self-assembly using Langmuir-Blodgett (LB) transfer or dip-coating. First, strategies to form mesostructures from a homogeneous Langmuir monolayer ...

We report on a method for the large-scale production of graphene micro-patterns by self-assembly-mediated process. The evaporation-induced self-assembly (EISA) technique was engineered to produce highly ordered graphene patterns on flexible substrates in a simplified and scalable manner. The crossed stripe graphene patterns have been produced over large area with regions ...

Experiments were carried out to optimize the performance of the neutron back-scattering (NBS) technique in landmine detection using an assembly consisting of three different layers placed above a (252)Cf neuron source, producing about 10(4)s(-1), in conjunction with a (3)He detector. The assembly was optimized experimentally. The selected assembly configuration was ...

Recent advances in the neuromorphic operation of atomic switches as individual synapse-like devices demonstrate the ability to process information with both short-term and long-term memorization in a single two terminal junction. Here it is shown that atomic switches can be self-assembled within a highly interconnected network of silver nanowires similar ...

Subacromial impingement occurs when tissues interposed between the humeral head and the acromion become compressed between the bones. Two fatigue-related mechanisms are suggested to contribute to this impingement: superior humeral head migration and scapular reorientation, specifically downward rotation, anterior tilt and protraction. Although both mechanisms have received attention, controversy exists ...

In recent years, there has been considerable interest in developing an ultra-low-field magnetic resonance imaging (ULF-MRI) system using an optically pumped atomic magnetometer (OPAM). However, a precise estimation of the signal-to-noise ratio (SNR) of ULF-MRI has not been carried out. Conventionally, to calculate the SNR of an MR image, thermal ...

Purpose. The aim of the study was to investigate the optic nerve head parameters of healthy macrodiscs to provide standard measurements for them to be the basis for future quantitative comparisons. Methods. Sixty-nine subjects with macrodisc (disc area larger than 2.82 mm2) and 91 healthy controls (disc area between 1.16 ...

Purpose: As multidetector computed tomography (MDCT) scanning is routinely performed for treatment planning in radiation oncology, understanding the characteristics of the MDCT x-ray beam is essential to accurately estimate patient dose. The purpose of this study is to characterize the x-ray beams of two commercial MDCT simulators widely used in ...

In recent years, self-assembled monolayers (SAMs) have been demonstrated to provide promising new approaches to nonlinear laser processing. Most notably, because of their ultrathin nature, indirect excitation mechanisms can be exploited in order to fabricate subwavelength structures. In photothermal processing, for example, microfocused lasers are used to locally heat the ...

Biological materials are often based on simple constituents and grown by the principle of self-assembly under ambient conditions. In particular, biomineralization approaches exploit efficient pathways of inorganic material synthesis. There is still a large gap between the complexity of natural systems and the practical utilization of bioinspired formation mechanisms. Here ...

Self-assembly behaviors of a series of systems (G1, G2, and G3) possessing same organic building blocks based on a substituted anthracene have been investigated in decalin. G2 and G3 are dominated by head-to-tail (ht) and head-to-head (hh) type dimers of G1, respectively. G1 gives a thermoresponsive gel which behaves ideally ...

Groundwater density is an important parameter in the interpretation of flow patterns. This paper investigates the relationship between electrical conductivity (EC) and groundwater density in coastal aquifers and evaluates the suitability of the UNESCO 1980 equation of state, developed for the world's oceans, for determining the density of groundwater based ...

Colloidal quantum dot (CQD) photovoltaics offer a promising approach to harvest the near-IR region of the solar spectrum, where half of the sun's power reaching the earth resides. High external quantum efficiencies have been obtained in the visible region in lead chalcogenide CQD photovoltaics. However, the corresponding efficiencies for band ...

PURPOSE: High power 980 nm diode laser ablation of the prostate using the side firing fiber has proven its efficiency and safety in treating lower urinary tract symptoms secondary to benign prostatic hyperplasia. Nevertheless, this procedure is associated with some drawbacks such as prolonged irritative symptoms and tissue sloughing. In ...

We study the linear instability with respect to necking of a filament of polymeric fluid undergoing uniaxial extension. Contrary to the widely discussed Considère criterion, we find the onset of instability to relate closely to the onset of downward curvature in the time (and so strain) evolution of the zz ...

A static vector magnetometer based on two-dimensional (2D) vibrating coils actuated by a piezoelectric cantilever is presented. Two individual sensing coils are orthogonally fastened at the tip of cantilever and piezoelectric sheets are used to excite the cantilever bending. Due to off-axis coupler on the tip, the cantilever generates bending ...

Dynamic acoustoelastic testing provides a more complete insight into the acoustic nonlinearity exhibited by micro-inhomogeneous media like granular and cracked materials. This method consists of measuring time of flight and energy modulations of pulsed ultrasonic waves induced by a low-frequency standing wave. Here pulsed ultrasonic head waves were employed to ...

Designing multidimensional radiofrequency pulses for clinical application must take into account the local specific absorption rate (SAR) as controlling the global SAR does not guarantee suppression of hot spots. The maximum peak SAR, averaged over an N grams cube (local NgSAR), must be kept under certain safety limits. Computing the ...

A neonatal head phantom, comprising of an ellipsoidal geometry and including a circular aperture for simulating the fontanel was designed and fabricated, in order to allow an objective assessment of thermal rise in tissues during trans-cranial ultrasonic scanning of pre-term neonates. The precise position of a series of thermocouples was ...

BACKGROUND: Suicidal gunshot wounds that are caused by ammunition fired from a 9-mm Luger pistol, with direct contact between the gun muzzle and the victim's head, present a serious injury pattern even with full metal jacket bullets. Wound ballistic experiments were performed to clarify whether muzzle gases from the firearm ...

Purpose. To compare the performance of Moorfields Regression Analysis (MRA) and optical coherence tomography (OCT) with that of photographic evaluation of the optic nerve head and retinal nerve fiber layer (RNFL) in the application of the Finnish Evidence-Based Guideline for Open-Angle Glaucoma (FEBG-OAG). Methods. Patients referred for glaucoma evaluation (n=312) ...

The ability to measure six degrees of freedom (6 DOF) head kinematics in motor vehicle crash conditions is important for assessing head-neck loads as well as brain injuries. A method for obtaining accurate 6 DOF head kinematics in short duration impact conditions is proposed and validated in this study. The ...

A four shell head phantom has been built and characterized. Its structure is similar to that of non-homogeneous concentric shell domains used by numerical solvers which better approximate current distribution than phantoms currently used to validate EIT systems. Each shell represents a head tissue, namely skin, skull, cerebrospinal fluid and ...

We present the first computational study investigating the electric field (E-field) strength generated by various electroconvulsive therapy (ECT) electrode configurations in specific brain regions of interest (ROIs) that have putative roles in the therapeutic action and/or adverse side effects of ECT. This study also characterizes the impact of the white ...

The boundary element method (BEM) is a useful tool in diffuse optical imaging (DOI) when modelling large optical regions whose parameters are piecewise constant, but are computationally expensive. We present here an acceleration technique, the single-level fast multipole method, for a highly lossy medium. The enhanced practicability of the BEM ...

We propose and experimentally demonstrate a novel simultaneous strain and temperature fiber optic sensor. The sensing head is formed by two concatenated ultra-short distributed Bragg reflector lasers that operate in single longitude mode with two polarization modes. The total length of the sensing head is only 18 mm. The two ...

The binaural auralization of a 3D sound field using spherical-harmonics beamforming (SHB) techniques was investigated and compared with the traditional method using a head-and-torso simulator (HATS). The new procedure was verified by comparing simulated room impulse responses with measured ones binaurally. The objective comparisons show that there is good agreement ...

We report a diode-pumped Yb:KYW amplifier delivering up to 27 mJ pulses at a repetition rate of 100 Hz and a spectral bandwidth of 5.5 nm, centered at around 1030 nm. The system is based on a double-head multipass amplifier configuration where the pump thermal load is distributed over two relatively thin laser crystals, ...

We demonstrated ultrafast femtosecond nonlinear optical (NLO) absorption characteristics of bilayered fullerosome vesicle nanostructures derived from molecular self-assembly of amphiphilic oligo(ethylene glycolated) C(60)-(light-harvesting diphenylaminofluorene antenna). Fullerene conjugates were designed to enhance photoresponse in a femtosecond time scale by applying an isomerizable periconjugation linker between the C(60) cage and diphenylaminofluorene antenna ...